Windows 10: PC works fine but end up on "No Signal" on monitor when I reboot it. Power off + power on...

Hi,So my computer works great and everything but when I want to reboot it windows menu => reboot it does so but ends up on "No Signal" from my monitor. Everything lights up just fine, motherboard and all.If I shut it down and press power on button again it boots normally without any issue.I cannot figure out what is causing it to not send any signal to monitor when I reboot but to send it perfectly fine when I shut down and power back up.Thank you in advance for your help...

:)

 

After power outage PC turns on, but there is 'no signal' on the monitor.

After a power blackout, I powered up my PC. It turned on but there was 'no signal' on the monitor. Then it just goes to sleep. My lap top and iPhone work fine. Unplugging and plugging didn't work. Besides getting a new computer or taking PC to hardware
tech, is there any other home remedy?

 

Pc starting but no power/signal to keyboard, mouse or monitor

Hi,

So I've had my gaming pc for a while now.

It runs fine but recently did a factory reset and followed this guide afterwards;ttps://www.youtube.com/watch?v=pJTCwSX9Ym8&list=WL&index=5&t=0s it was fine and so I left it on just downloading a game a few days later, nothing unusual. I came back to it
on but no signal on monitor and no power to keyboard and mouse. I've tried going back to a restore point before following the youtube video and still not working so I don't think that's the problem.

Operating System - Windows 10

Device - Zoostorm Computer

Specs -

ProcessorIntel(R) Core(TM) i7-4790 CPU @ 3.60GHz

Video CardNVIDIA GeForce GTX 750 Ti

Video Card #2NVIDIA GeForce GTX 970

RAM16 GB

Operating SystemWindows 10

But it had been working fine, the only thing I could think of is if I had a pre-existing virus or something that was causing this but surely that would've done this sooner. Anyway, right now when I turn my pc off it does the above again, power to the pc
but no keyboard or mouse power and no signal to keyboard. I have figured out that if I take one stick of RAM out (I have two 8gb RAM) and start it up on just one it all boots up and powers everything fine. I then it off, insert the other stick of RAM and start
it up again and it works. But then I power it off at the end of the day and have to repeat those steps again the next morning. This has been happening for a week-ish now and it's just getting time consuming and annoying to do everyday.

Any help or advice would be appreciated.

Thanks, Lewis.

 

PC works fine, no video signal or power to keyboard and mouse?

Hi, my PC has not been operational for about 2 weeks, and I'm not getting video signal and there is no power to my keyboard and mouse.
What I have tried to solve the problem:

• Connected PC speaker
• Disconnected hard drive

Please note that all of my components are working I think that this is a software/BIOS problem?
Specs:

• Intel Core i5 6600
• Asus B150M-AD3
• 8gb DDR3 1333(1x)
• Gigabyte GTX 780Ti

Thanks
EDIT: I have tried removing my CMOS battery, and the same thing happens. Was I meant to short the pins again? Did I do something wrong? Thanks
Edit 2: I removed the battery, discharged the capacitors and it STILL happens? Is my motherboard dead I really hope this isn't the case *Frown