Windows 10: please help with this Automatic Repair, you can not get everything out, please help with.

please help with this Automatic Repair, can not get out of everything, please help with the chunadigans.

:)

 

HELP! Windows 10 automatic repair couldn't repair PC. Details below

Hi Matthew,

As you are facing issue withAutomatic Repair, we would assist you for sure.

In order to understand the issue in a better manner, please share the following details

• 
  I tried system restore” What is the error exact error message you received?
  

If automatic repair fails, you may try to repair them using these commands through Command Prompt under Advanced Options. Follow the steps:

Since you have done most of the troubleshooting steps, I would suggest you to try repairing the Boot Configuration Data through the command prompt by following the steps below and check if it helps.

I suggest you re-built the boot record by following the below commands and check if it helps.

You will have to use Windows 10 installation media to follow the steps to boot into Recovery Environment and try to rebuild BCD.

Step 1: I suggest you to create an installation media for
Windows 10 using the media creation tool:

Installing Windows 10 using the media creation tool

Step 2: After preparing the installation media, insert it hard reboot the device and follow the below:

• Boot into Windows Recovery Environment using the Windows 10 installation media.
• Click on Repair your computer.
  
• Click on Troubleshoot and in the advanced options.
• Select Command Prompt. Type the following commands into the prompt and press Enter key after each command.

• 
  bootrec /fixmbr
  
• 
  bootrec /fixboot
  
• 
  bootrec /scanos
  
• 
  bootrec /rebuildbcd
  

5. Restart the computer.

NOTE: Modifying BIOS/ complementary metal oxide semiconductor (CMOS) settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee that any problems resulting
from the configuring of BIOS/CMOS settings can be solved. Modifications of the settings are at your own risk.

Hope it helps. Reply to the post with an updated status of this issue for further assistance.

Thank you.

 

help to remote connect

not sure how to use both programs u 2 suggested, i need more helpful steps thanks

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.