Windows 10: Plugged in but not charge the Battery and stuck at 0%

I have lenovo ideapad gaming 3 intel i5 gtx 1650 laptop and I update windows 11 24h2 update. I use daily after update and work normally but one day I open laptop and working around 2 to 3 min and suddenly switch off . I plugged the charger and on the laptop . I saw my laptop work normally but battery stuck at 0% . I plugged around 2 to 3 hours but problem is same . I checked battery health from prompt it's about 80% full charging capacity remain and update, uninstall battery drivers and I want to update BIOS but my battery at 0 % and for update BIOS need battery charge above 30% but problem

:)

 

Plugged in but battery does not charge

If the laptop works without the battery then charger is functioning correctly. Take a cloth with a bit of rubbing alcohol on it (or some on-the-go alcohol swabs), and clean the metal contacts that connect your battery to your laptop.

Make sure to install all Windows important updates.

Install latest versions of your laptop device drivers you can download the latest device drivers from the device manufacturer or from your laptop manufacturer website.


Step 1

1. Shutdown your laptop.

2. Remove the battery.

3. Connect the AC power adapter to your laptop.

4. Power on the laptop

5. Open the Device Manager by typing Devmgmt.msc into Start Menu or from Control Panel.

6. Under the Batteries category, right-click all of the Microsoft ACPI Compliant Control Method Battery listings, and select Uninstall (it’s ok if you only have 1).





7. Shutdown the laptop.

8. Insert the battery.

9. Power on the laptop.

If above suggestions wont resolve the battery charge issue then follow below steps.




Step 2

1. Shutdown the laptop.

2. Remove the battery.

3. Start the laptop with only AC adapter connected to laptop.

4. When you login to Windows OS connect the battery while Windows OS working.





Step 3

Reset the System Management Controller. Use one of these methods to reset the SMC, which controls battery management, battery status light.

1. Shut down the computer and disconnect the power cord.

2. Remove the battery.

3. Press and hold the power button for ten seconds.

4. Reattach the battery and AC power adapter, then start up the laptop.


Hopefully one of the above suggestions will help you resolve the battery not charging problem. If battery still doesn't charge, you may need to replace your battery.

 

0% availability (plugged in, charging)

If the battery is old it might have run its course but if that's not the can do the following to check what the problem

Computer laptop that is plugged in but not charging

• Shutdown the laptop
• Remove the battery ( note some batteries cannot easily be removed you may need to consult your laptop manual on how to remove them)
• Clean the battery and terminals with a dry clean cloth
• Put the battery back
• Turn on the laptop
• If it still say plugged in but not charging dont panick continue to follow more steps below

Reinstall Microsoft ACPI-Compliant Control Method Battery.

This is the software that control battery settings power mode and so on

This article describes the steps in detail
http://accatech.com/dell-laptop-plugged-in-but-not-charging-fix/

 

Windows 10 - Battery "Plugged in, not charging"

From the moment I updated to Windows 10 my laptop battery has 0% charge and will not work without being plugged in and says "0% available - plugged in, not charging" Can anyone suggest a fix that doesn't involve turning on without being plugged in as that
doesn't work?