Windows 10: power shell and updater starting with every reboot of windows 10

For the past month, every time I try to start windows 10, it takes a long time to boot, then after login it goes directly to execute powershell. No section or anything starts, just a blue screen. By exiting 2 or 3 times it goes away and the uploader starts. Does not execute anything, just waits. When I exit from that program with 2 or 3 tries, or cont alt del to bring up the task manager and stop the process it continues to my regular screen, but no program will actually start for a couple of minutes. Then I finally try to execute Microsoft Edge or any other internet program. I must start it at least 2 times for it to be stable enough to allow me to work on the internet. I have thought about re-installing microsoft, but I don't want to loose the 30 or so programs I have on the computer, and I will admit that I have lost the license information for 3 or 4 of my favorite programs, and don't want to have to pay for new copies. Does anyone have any suggestions?

:)

 

Windows Shell Experience Host using 35 to 55% of CPU usage on Windows 10

Hi Don,

Thank you for posting in Microsoft Community, we appreciate your interest in Windows 10.

I understand your concern about CPU utilization by Windows Shell Experience Host, we will help you with this issue.

I suggest you to try few of the below troubleshooting steps and check if it helps.

Step 1: Try to end the process from Task Manager and check.

• 
  Press Ctrl+Alt+Del together to open
  Task Manager.
  
• 
  Go to Processes tab, right-click on the Windows Shell Experience Host process and click
  End Process.
  

Step 2: Boot the computer in to Safe mode with networking and if the CPU usage is same.

Refer: Start your PC in safe mode in Windows 10


Step 3: I suggest you to install all the pending updates after upgrade to Windows 10.

• Connect to the internet.
• Press Windows key and type
  updates.
• Click on Check for updates.
• Under Windows Updates, click on
  Check for updates.
• Try to install the updates being shown.

Also, visit the computer manufacturer’s website and install the drivers being found and check if it helps.

Hope it helps. Reply to the post with an updated status of this issue for further assistance.

 

Windows Power Shell

When I start Win 10, Win Power Shell 1.0 comes on the screen and stays there, empty for 1.5 to 2.0 min, locking up the screen and the system for that time. What can I do to keep Win Power Shell from coming up? I have tried to shut it off everywhere I
can find it. This started with the August Routine update.

 

FIXED!! Windows 7 sp1 never ends searching for updates

Ok I did another reboot, disabled windows update service, did step 3 again, this time it installed an update, enabled windows update service and did a reboot and voila!! *Peace eace: