Windows 10: print job is not in correct format.

Recently my printing jobs have not been printing in the correct format. I have tried printing from email, and the internet and there is no difference. What should be one page is eight and the photos and graphics are not printing. What is printing, is text but in a strange format. I did the unplug replug step/ restarted the pc/ran the trouble shooter/ made sure that windows chooses the right printer and nothing.

:)

 

Windows print problem. Every Time! Printer prints job, but on PC it still says "Printing" and no additional job will print.

This happens EVERY time.

It happens on two different printers on two different networks (at home and at work)....so it is a WINDOWS problem, not a PRINTER problem.

Send a job to the printer.

It completes and prints JUST FINE. All is well.

THEN==>>

In the printer window for that printer, it continues to say "Printing" (forever!) even tho the job has successfully completed. If i highlight the job and "Delete" it, it says "Deleting"....forever. No other print job sent will print, as they are all blocked
behind the job that has already successfully printed, and that cannot be manually deleted, either.

So, EVERY TIME the queue must be manually cleared out. The only way i can print another job is a 3-step process

• Go to Services, Stop print queue.
• Go to PRINTERS folder, delete all files.
• Go back to Services, and START print queue.

After those three steps, I can print again...exactly one print job...then it happens the same again for that job. Obviously this is a complete hassle.

I would like specific and definitive instructions not on how to now get WINDOWS to work "normally"...so that when a print job successfully prints and is done, the queue for that printer shows as empty, and so more print jobs can be sent.

If this were a very intermittent occasional problem it might be tolerable. But it happens EVERY TIME with EVERY PRINTER.

Help!

 

Print jobs stuck in print quese

My wife recently changed from Chrome to Firefox on her laptop. Afterward the system would hang whenever she tried to print something. I looked and it seems that jobs get stuck in the print queue after printing. There was a test page and another job. I was able to cancel the other job but the test page won't cancel. Restarting the print spool service resulted in the test page printing but remaining in the queue in printing status.

What should me next steps be?

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!