Windows 10: print spooler

after each update you make mess in my PC


or lets say ...no printer works

always say that print spooler does not work


than I go to services and found print spooler, open it and press START.... in about 10 sec. just by it self jumps in STOPPED --or let say simples , he turn him self down

Even than on left side of list still say STOP or Restart.....like still works


If I tray to print something in that 10 seconds that works , happens that page is half printed as print spooler turns off by him self.


I must say That I am realy disapointed that after each Update that happens and Now I do not know how to start it and all my bussines depends on printer which can not print.


Urgent , help and solution


regards

Wish

:)

 

Print Spooler Issue

Hello Sree,

For step by step instructions on how you can manually start the Print Spooler Service, follow these:

• Click Windows tab.
• Type Control Panel > System and Maintenance
  > Administrative Tools.
• Double click Services.
• Right click to the Print Spooler service > Properties.

However, we suggest you can refer to an answer given by Prabhavathi Patil on this

thread.

We also recommend that you update the driver for your printer.

Let us know if you need further assistance.

Thanks.

 

Must restart Spooler to print

Have you set the Print Spooler server to Automatic? If you haven't, then let's do it. Follow the steps below:

• Open Services through the search box.
• Locate Print Spooler service and double click it.
• Once the Print Spooler Properties window is open, look for Startup type and set is to
  Automatic.
  
• Check also the Service status and make sure that it is set to Started.
• Click Apply, then OK.

In case there are other printers installed on your PC that you no longer use, we suggest that you uninstall it as it may also cause some issues with Print Spooler.

Looking forward to your reply.

Regards

 

Print spooler

Hi Marty,

To assist with your concern, follow the steps provided below on how to enable Print Spooler under Services:

• Click "Start".
• Type "Services.msc".
• Double-click "Print Spooler" in the Services list.
• Startup Type must be set to "Automatic".
• If the Service Status was "Stop", click "Start" then "Apply" and click "Ok.

Update us on the result.

Thank you.