Windows 10: printer likes to sit around offline

Every flaming time I go to print, I have to run the Print And Scan Doctor. My printer is selected as the default. It is always listed as offline. How do I put the flaming thing online? Why is that not right there in the control panel under the "manage" tab for the flaming printer? Thank you sooo much if you can help!

:)

 

Printer offline

Hi there,

Thank you for writing to Microsoft Community Forums.

Could you please help me with the below question:

• Did you make any changes to the computer before this issue started?
  

Printer will continually switch itself to offline mode due to an IP port issue. To keep the printer from switching to offline mode, you must validate the printer's IP address.

Meanwhile, please follow the troubleshooting steps as mentioned below:

Steps:

1. Press Windows andR
   key together on your Keyboard.
2. Type Control and hit enter.
3. Click on Hardware and sound> click on Devices and printers.
   
4. Select the HP Printer 2540, right click on it.
5. Uncheck the option use printer offline and select
   properties.
6. Go to the Ports tab at the top of the pop-up window.
7. Click on "Configure Port"
8. Check that the "Printer Name or IP address:" box is the same as the IP of your printer.

You can also refer this link for more information
about Printer issues.

Hope it helps.

Roohi Taj S

Microsoft Community - Moderator

 

Printer Offline

Hi Laurel,

For us to isolate your Printer Offline concern, we would like to know the following:

• Were there any changes made on your computer prior to the issue (e.g., updates, software installation)?
• Is this the first time you experienced the issue?
• To make sure that we have not missed on anything, what troubleshooting steps have you done so far?

We look forward to your response.

 

Networked Printer showing "Offline"

Hey guys,

I'm having a slight issue with one of my printers in that it's showing offline and I can't print to it.

It's a Datamax label printer which is connected to my network via a Netgear print server, this has then be added to one of my servers for sharing etc.

So far I've tried the below.

- Classic on/off.
- Removing from server and re-adding.
- Ensuring that under port configuration SNMP Status is disabled.
- Assigning to different IP.
- Restarting Print Spooler.

I can ping it fine and the printer itself is letting me do manual test prints using its interface, but no matter what I cannot get it to stop showing up as offline and allowing me to print to it over the network. I should add that it's worked fine for the past year.

Any suggestions?