Windows 10: Printer will not print nor scan after installing new ssd, on a fresh windows 10 install.

Gone through lots of troubleshooting, restarted printer and removed device about 100 times but will not seem to print. Any help on how to just add a printer again so I can scan some stuff to my pc would be helpful. THanks

submitted by /u/StepDiceYT
[link] [comments]

:)

 

Installing Windows 10 on New PC?

I'm going to be building a new PC on Christmas and want to install Windows 10 on it. I have Windows 10 on my current PC, which I installed upgrading from 8.1 with the files on a USB. How do I go about installing a clean copy of Windows 10 on this new PC? I think I recall something about installing it once makes Microsoft recognize your hardware, but since this will be a PC I'm not sure what steps I need to take. Do I need to go 8.1 -> 10 or is there a method of going directly to 10?

 

Fresh Install of Windows 10 Home in new SSD

I have this Dell N4010 Laptop that I want to upgrade with an SSD and use the existing HDD as Data drive. I have an original windows of digital license.

Please suggest how I can install a fresh copy of the windows in my new SSD with the existing license. And please suggest how to activate the new installation of Windows.

 

Can't "Scan To" from printer. Please help!

The scenenario is the following:

We have multiple subnets in our network. One of them is the security one which is 10.224.2.xxx

Computer A is connected directly into it. Ethernet cable comes out of the wall and goes into her Intel NIC.

Computer B is also connected directly into it. However, ethernet cable comes out of the wall, goes into a dock and then through the USB cable, gets internet.

Computer C is connected to our wireless security network which is 10.224.4.xxx
This computer is allowed on the firewall to talk to 10.224.2.xxx

All three computer have Webroot SecureAnywhere installed. The printer is an EPSON Workforce WF-4640. IP is 10.224.2.122 / 255.255.254.0 / 10.224.2.1 gateway / no iPV6 / 192.168.50.18 & .19 are DNS's. Printer has static IP.

I proceeded to install the drivers on all three computers. Here is where the problem comes.

Computer A installs just fine. Finds the printer on the subnet and completes installation. I can print and scan FROM the computer. I can also scan FROM the printer. When I go to "Document Capture Pro", I can see scan to: COMPUTER A on the list.

Computer B also installs just fine. Finds the printer and completes the installation. I can print and scan FROM the computer, but I cannot scan FROM the printer. It just wont list COMPUTER B at all!. I tried plugging the ethernet cable directly into the laptop, but still, the printer will not show computer B in the scan to list.

Computer C the same story, but worse. I cannot finish the installation properly because it will not find the printer. It is obviously on a different subnet, but it will not let me type in the address so I just cancel the printer finder part. I manually go to control panel and adjust the IP parameters. Same thing, I can print and scan from the computer but cannot scan FROM the printer. It will not list Computer C in the list.

I have tripled checked the EPSON Scan software on each PC. Each has the IP parameters set properly. I have spent days installing and reinstalling drivers, but no luck. Printer has updated firmware. I tried disabling Windows firewall, nothing.
At first I wanted to think it was Webroot, since there is a review on Amazon from a guy that had the same problem, but using Norton. However, how come Computer A works just fine?
When I though it was the dock, I quickly found out it was not as explained in Computer B when I plugged it directly.

At this point, Im running out of ideas. Im not even sure where else to go.