Windows 10: probleme ipv4/ ipv6/ Windows 11 professionnel/ wacom mobile studio pro 13'

Bonjour a la communauté Microsoft. navré je ne sais pas si le Topic est "Performance and system failures" ou "Desktop, start and personalization"Deroulé:Il y a de cela une semaine 13/12/24 j'ai eu un problème sur un ordinateur sous Windows 11 professionnel.Après avoir allumé la machine normalement. Celle-ci s'est éteint au bout de 20 min sur un écran bleu de cette nature. "your device ran into a problem need to restart....."Ainsi que des messages problèmes comme ceci. "EFI pxe 0 failed""boot ipv4/6 failed"Suite à cela je tente de diagnostiqué la chose et vais voir dans l'UEFI. et tombe

:)

 

Windows 10 ....IPV4 and IPV6

In Settings Network Windows 10 has IPV4/IPV6 defined as 192.168.0.11/24.... Does that mean IPV4 & IPV6 are using ports 11 thru 24? If so why are they defined this way?

 

Connectivity (IPv4/IPv6): Disconnected

Hi,



Thank you for writing to Microsoft Community Forums.



Ideally this Connectivity (IPv4/IPv6): Disconnected, means that the devices in not in use or not connected and it could be any device for example, Ethernet, WIFI, Bluetooth or Local Area Connection.



If you are using WI-FI for internet connection then Ethernet will show Connectivity (IPv4/IPv6): Disconnected.



In order to understand the issue and assist you accordingly, we need some information

• What is your network setup?
  
• Are you seeing any errors?
  
• Where you are seeing this information?

Meanwhile, try the troubleshooting steps referred in this article:

Fix network connection issues in Windows and check if it works.



Regards,

Aditya Roy

Microsoft Community – Moderator

 

Prefer ipv4 over ipv6

hi, I want to set ipv4 to be preferred over ipv6, the other day i've used the tips from this Ping returns IPv6 Address, ping IPv4 in Command Prompt - TheITBros on my 2 windows10 computers and everything worked out great! Now, i just did a win10 update and i noticed that that no longer works even by doing the very same "command" and it kinda gets ignored. Did they just remove the functionality? This is what i get from netsh interface ipv6 show prefixpolicies (i don't get the longer list anymore but just these):

So it seems to be preferring ipv4, yet when i ping my site (available on both ipv4 and ipv6), i get output with ipv6, same as google.com - the other day it was working nicely to ipv4 and i only used these 2 commands they suggested: netsh interface ipv6 set prefix ::/96 60 3 netsh interface ipv6 set prefix ::ffff:0:0/96 55 4 what's going on? I don't want to disable it completely (i know i can disable it from the router or from the network card properties, i just want to de-prioritise it) [Version 10.0.19044.1387] thank you, Gabrio - - - Updated - - - might have answered myself, i've added netsh interface ipv6 add prefixpolicy ::/0 40 1 and it did the trick... i wonder if it will stick now