Windows 10: Problems With Macrium Restore

I have used Macrium for quite a while and been very pleased. However, lately I cannot run a restore successfully. I can backup my drive just fine. But when I try to run a restore, the error Oc000000F comes up instead. This is following the install of the latest Windows updates: KB4532693 and KB4538764. I have essentially eliminated Windows as the culprit by running an repair/install successfully. Windows Update downloaded and installed updates during the process. I have uninstalled and reinstalled Macrium several times to no avail.

Is anyone else experiencing this issue? Is there a resolution? What is an alternative to Macrium if I cannot get the restore process to work? I did create a System Image as a backup measure.

:)

 

Restoring Windows 10 Image using Macrium Reflect


In addition to the above. Here's my suggestion in step by step.
I assume you have Macrium Installed in your current HD and already made a backup copy.

1. Connect your new HD via USB port and boot up.
2. Run Macrium, click on Restore tab then select the Backup Image that you made to restore
3. click on "select a different target disk" then select your new HD as destination
   
   
   
4. Proceed to restore then Shutdown and disconnect the old HD and replace with the new HD
5. Boot up with your new HD.

 

Windows 10 1709 System Restore problems...


That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.

 

System Image Problem


Hi Nick,

No need to stress.
Since the dl of the windows install media failed twice in a row already we are going to do as Bill suggests.
No use wasting another day on it at this point.

Here is a description of the steps to follow:

- Connect the external drive that contains the Macrium images we made.

-Boot off of the Macrium rescue CD. Make the necessary changes in bios so booting from CD is the highest on the boot order priority list or use the machine's bootmenu (Fn key ? ) to select to boot off of CD.

- From within Macrium select restore. Browse for image 0_SysRes etc. and load it in Macrium.

- Select the drive to restore to: your c: drive. Make sure it is the correct drive. Only one internal drive should be connected at this point.

-Drag and drop the loaded backup image to the beginning of the C:\ partition. It must be fully at the left of the partition.

- Click restore and confirm.

- Once it has finished close Macrium. It will automatically reboot.

-Boot again off of the CD.

-Macrium loads and select restore again.

-Browse for and select 1_Windows from the backup drive. Select the same destination drive and drag and drop it right next to the small partition we just restored. Click restore, confirm the overwrite and let it finish.

-Again close Macrium and reboot once more off of the cd.

-In Macrium on the top left hand side there a menu option that reads something along these lines (I'll load it in a few minutes to verify and correct if necessary) : "Fix Windows boot problems".
Click it.

-Let it finish and reboot off the main hard drive this time.

- Cross your fingers and hopefully Windows will start up.


I suggest not doing this immediately. I hope Bill will have a look at the suggested steps and correct any if need be.

Best, *Wink