Windows 10: PROBLEMS WITH SEND TO

I am unable to right click on my mouse to get the send to, i.e. fax recipient, compressed file. It stopped working this week. I did not do anything different. I tried to look up send to compressed file and it opens in Word.

:)

 

Windows 10 1709 System Restore problems...


That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.

 

Laptop updated to 1809. Can't get WOL to send out...


Not sure the topic is exactly accurate. Here's the story:

• Have been successful sending WOL to 2 other PCs in the house
• Had problems with laptop and sent to HP. They upgraded it to 1809
• Now when I send WOL packets the other PCs will not wake up

Given that it was working fine on those PCs before, and the noted changes are to the PC sending the packet, I'm assuming that my sending PC needs something configured.

My searches on WOL only find stuff about setting it up on the remote PC so it will wake up.

Any suggestions about why my sending PC is not sending?

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".