Windows 10: Processor speed stuck at 0.78Ghz while charging.

Hello Please Help me here, When I plug my AC adapter after 2-5 minutes my processor speed becomes 0.78GHz I have tries everything I could do like customize the power plan and set the processor power management to 100% while plugged in and even on the Battery. I have cleaned the laptop. It has heat sinker not fan. I charge it with the original adapter. Please help me to solve this issue. I have to restart the PC to make it normal to work. Please do not suggest throttlestop as it is not supported by my CPU. PC specs are attached

:)

 

speed of processor 1 in group 0 is being limited by system firmware !?

I am seeing several messages in the event log shortly after I boot (the adapter message appears earlier than the processor messages):

• A command sent to the adapter has timed out. The adapter did not respond.
• The speed of processor 0 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.
• The speed of processor 1 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.
• The speed of processor 2 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.
• The speed of processor 3 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.

What could be causing this? My firmware is up-to-date.

 

Charging stuck at 70%

If the laptop works without the battery then charger is functioning correctly. Take a cloth with a bit of rubbing alcohol on it (or some on-the-go alcohol swabs), and clean the metal contacts that connect your battery to your laptop.

Make sure to install all Windows important updates.

Install latest versions of your laptop device drivers you can download the latest device drivers from the device manufacturer or from your laptop manufacturer website.


Step 1

1. Shutdown your laptop.

2. Remove the battery.

3. Connect the AC power adapter to your laptop.

4. Power on the laptop

5. Open the Device Manager by typing Devmgmt.msc into Start Menu or from Control Panel.

6. Under the Batteries category, right-click all of the Microsoft ACPI Compliant Control Method Battery listings, and select Uninstall (it’s ok if you only have 1).





7. Shutdown the laptop.

8. Insert the battery.

9. Power on the laptop.

If above suggestions wont resolve the battery charge issue then follow below steps.




Step 2

1. Shutdown the laptop.

2. Remove the battery.

3. Start the laptop with only AC adapter connected to laptop.

4. When you login to Windows OS connect the battery while Windows OS working.





Step 3

Reset the System Management Controller. Use one of these methods to reset the SMC, which controls battery management, battery status light.

1. Shut down the computer and disconnect the power cord.

2. Remove the battery.

3. Press and hold the power button for ten seconds.

4. Reattach the battery and AC power adapter, then start up the laptop.


Hopefully one of the above suggestions will help you resolve the battery not charging problem. If battery still doesn't charge, you may need to replace your battery.

 

Processor Speed

Hi everyone!

I am using an HP Notebook, with an Intel i3 5005U processor and 4Gb of RAM.

Can anyone help boost my processor speed? It's locked at 0.78GHz and does not go to 2GHz unless it goes over 60% utilisation. Any suggestions without damaging my laptop?

Please let me know what do to.