Windows 10: Qcamain10x64.sys Blue Screen

I seem to be getting the Qcamain10x64.sys Driver_IRQL_Not_Less_Or_Equal blue screen a lot. I have done the sfc /scannow and also chkdsk :c /f. I have even tried to update my driver and uninstalled it. It seems to be fine for now but it might be broken later again.... it usually happens and then its good for a while and it happens again.Any other solutions?

:)

 

blue screen on Windows 10 Qcamain10x64.sys

I am getting a blue screen on my dell laptop windows 10 with an error message Qcamain10x64.sys. what should do?

[Moved from: Windows / Windows 10 / Network & internet]

[Original title: blue screen on windows 10 Qcamain10x64.sys]

 

blue screen on Windows 10 Qcamain10x64.sys

Hi,

The blue screen error that you’ve may be caused by an incompatible driver or a software conflict has occurred. Regarding this, may we confirm if you’re also getting same
Qcamain10x64.sys error message?

Also, we can try to isolate this concern by performing a clean boot. This troubleshooting technique will help us determine if there conflicts with other applications. Please click
here for the steps.

Once you’re in the clean boot state, navigate to your computer and see if you’ll get the same result.

Note: After the troubleshooting, refer to this section: “How to reset the computer to start normally after clean boot troubleshooting” on the same support
article to boot the computer in normal setup once the issue has been resolved.

We’ll wait for your update after trying the steps.

 

BSOD qcamain10x64.sys - Lenovo Yoga 520-14IKB

The minidump file showed a SYSTEM_THREAD_EXCEPTION_NOT_HANDLED_M (1000007e) stop error also caused by the Qcamain10x64.sys :

BugCheck 1000007E, {ffffffffc0000005, fffff80ab3af8058, fffffa0c9c93f1e8, fffffa0c9c93ea30}

*** WARNING: Unable to verify timestamp for Qcamain10x64.sys

*** ERROR: Module load completed but symbols could not be loaded for Qcamain10x64.sys

*** WARNING: Unable to verify timestamp for win32k.sys

*** ERROR: Module load completed but symbols could not be loaded for win32k.sys

Probably caused by : Qcamain10x64.sys ( Qcamain10x64+f8058 )

Can you do the following :

In the Device Manager double-click the wireless adapter > Driver

What is the "Driver Version" ?

Then click on the "Details" tab, then choose "Hardware Ids" from the drop-down menu under "Property".

What is listed under "Value"?