Windows 10: Ram/driver bluescreens & crashes

So I've been having issues with my computer crashing applications and bluescreening when it feels like it. Specifically with stop code attempted write in read only memory, and stop code memory management. I got new ram sticks, reinstalled windows, tried going through my drivers and idk what to do. If you need minidumps or memory dumps, I don't know how to do that so please provide a link

:)

 

Constant Bluescreens/Crashes

I did that during the part where i set all the stuff to how LifeOnMars suggested

 

Bluescreen Crashes in Windows 10

There are a few things that I notice with these errors, they are nearly all hardware 0x124 errors which are difficult to troubleshoot because there is so little information.

Most of them occur when the Norton Security process is running so a first step would be to uninstall Norton and just use Windows Defender while we are troubleshooting.

There was one different BSOD error: 0x18 Reference by Pointer
Probably caused by : BHDrvx64.sys ( BHDrvx64+114761 )

You need to update or rollback your Symantec Heuristics Driver. Maybe this is part of the Norton install so it may be removed anyway.

Check if there has been any improvement and if not then you will need to work through your hardware:



STOP 0x124 Troubleshooting [/i] Read carefully before proceeding.



Warning

If you're overclocking your system, revert back to stock clocks now.





Note Test the system once the overclock is removed before continuing with the steps outlined below.

Part One: CPU Stress Test
Part Two: MemTest86+ RAM Diagnostic
Part Three: Hard Drive Diagnostics
Part Four: GPU Stress Test




ONE [/i] CPU TEST
*Arrow Run Prime95 to stress test your CPU. Prime95 - Stress Test Your CPU - Windows 10 Forums



Warning Your CPU temperatures will rise quickly while under this stress test. Keep a keen eye on them and abort the test if overheating occurs.




TWO [/i] RAM TEST
*Arrow Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums



Note



MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.




THREE [/i] HDD TEST


Note Please run HDTune first, in the order posted!
*Arrow Run HDTune to

• check the health,
• scan for errors, no quick scan but full scan
• run a benchmark.

It may take some time, but please take the time you need to perform it properly.
When above is done please make screenshots of the following

• the health,
• the error scan,
• the benchmark incl. following
  • transfer rate,
  • access time,
  • burst rate,
  • cpu usage.

*Arrow Run chkdsk




FOUR [/i] GPU TEST
*Arrow Run Furmark to stress test your GPU. FurMark - GPU Stress Test - Windows 10 Forums



Note Run Furmark for around 30 minutes.


Warning Your GPU temperatures will rise quickly while Furmark is running. Keep a keen eye on them and abort the test if overheating occurs.


Report back on all the tests as you do them - take your time - there is no need to get them all done immediately.

 

Constant Bluescreens/Crashes

did you set the ram voltage to 1.65v? i saw no mention of you following that step