Windows 10: Ramesh is a good boy from bankatwa

Nine people were dead and another was clinging to life in Nevada after a car raced through a red light and slammed into several vehicles, North Las Vegas police said.Officer Alexander Cuevas, who called Saturday's crash a "chaotic event," said the age of those killed ranged from young children to middle-age adults.“We have not seen a mass casualty traffic collision like this before,” Cuevas said. Cuevas said a preliminary investigation indicated a Dodge Charger was speeding as it approached a major intersection at about 3 p.m., then ran a red light. Several cars and 15 people we

:)

 

[FS][US]   AMD x6 + AM2+ motherboard + DDR2 RAM + Sound Card = Insanely low price!




Just added this bad boy to the list! Insanely good sound card allows for maximum audio quality from BF3. Good to hear foot steps. All in all just a bad @55 card

 

Windows Updated(16299.309).KB4088776 Restart is required to complete.

Hi dalchina. Good news, I followed your suggestion and reinstalled the update and now it appears as "installed correctly" *Biggrin Maybe it was not necessary to run the Windows Update Troubleshooter or maybe if necessary. But using it I do not think it could have worsened something. The installation was very fast, unlike the first time it showed step 1 and step 2 completed.

Thanks for the suggestions and for the time to respond Best regards.


And thanks for the tip of that program, I'll have it on my list.

 

All right boys, opty it is

Good thing I wrote all this down so I don't have to type this every time someone asks *Stick Out Tongue
Step one- Set time, date
Step two- In CPU settings, disable cool n quiet, set memory clock to DDR400, play with memory timings (CAS-TRAS-TRP-TRCD), which are listed in the bios in the order CAS, TRCD, TRAS, and TRP.
Leave MA timing at 2T unless you think your system can handle 1T
Step three- in Chipset settings, enable onboard LAN, disable onboard Audio, disable AGP fast write, set primary graphics adapter, and set CPU-NB and NB-SB link speed to 1000mhz.
Step four- in IDE, disable controllers you aren't using. On all drives detected, enable SMART if you can and set PIO/DMA as high as they will go.
Step five- Enable legacy USB support
Step six- Set password if you're worried about anyone screwing around with your BIOS settings
Step seven- Configure your boot sequence. I reccomend hard drive first, optical drive second, and floppy drive third.
Step eight- Save changes, boot into XP, and enjoy your computer