Windows 10: Random Startup Flash

This is just a simple request but I would appreciate it if anybody could help me on this problem. My Windows 10 computer works mostly fine when it boots up, but for some reason it briefly flashes at the beginning, where the screen briefly turns off and then turns back on at the beginning for a low percentage of a second. My monitor does not flicker hugely or anything like that and works just fine in the long run, but I'm wondering if there would be a simple solution to somehow have my computer screen boot up without briefly flashing on and off.

:)

 

Can't get GPU-Z to start with Windows 8.1 startup

I'm not sure how to do that. Could you list the steps for a noob?

 

Random Restars - > Video Card - > PSU

Yep Frogger's dead on. Do some more research, find some instructions, they will list it step-by-step. Print or write down what instructions you'll need. I hope it works for ya!

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!