Windows 10: RDP access issue

Unable to access my computer using RDP, looks like the password has not been synced.During Windows 10 installation local a user was created, but after installation an MS account was attached. And now I can't access PC with MS credentials. How can I sync user password?

:)

 

Guidance needed to setup my Home PC access over Internet through browser

I wasn't giving steps on how to get RDP working, that is covered plenty of other places, I just give the steps to make it secure.

RDP. If they aren't tracking your Web browsing, I doubt they are going to track RDP.

And if you start the session from the command prompt it doesn't even put the address in the MRU list.

Though the question that needs to be asked now is, what are you using for your VM lab?

 

RDP

Hi Nikki,

We can see here that you are having issues using (RDP) Remote Desktop Protocol on your computer. There are several reasons why you are experiencing this concern. To set your expectation, we will be doing some troubleshooting steps to isolate
this problem. Before we proceed, may we know the following:

• Any changes made on the computer prior to this concern?
• What troubleshooting steps have you tried so far?
• Is this the first time that you encountered this problem?
• When did you notice about this issue?
• Can you send us a screenshot with the error message that you are getting? Note: Please do not include any personal information.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.