Windows 10: "reboot and select proper boot device" after windows 10 installation restarts my computer

Recently i've upgraded my pc. I decided to install windows 10 to my ssd using a usb stick. However, there is a point during the installation where the pc is required to restart, but instead of continuing the installation, it just shows a message on screen saying "Reboot and Select proper boot device or insert boot media in selected boot device".I really don't know what to do, i tried everything i could come up with.

:)

 

Reboot and Select Proper Boot Device...after reboot?

Hello all. Getting a little frustrated here. A couple of weeks ago we had a user come in on a Monday morning to find that her pc was displaying the classic message "Reboot and select proper boot device...". Tried popping in a windows disk and fixing the MBR, no luck. Ended up reinstalling windows and her few programs back on it. All was good after this. For about a day. She came in the next day to find the same message. So at that point we decided that more than likely the drive was bad even though oddly enough it tested out fine. It was a Corsair 60gb SSD.

Last week we swapped that Corsair with a 64gb Crucial SSD and installed Windows. We then created a backup image of that drive. All was good until Thursday when her power strip that the PC was plugged into got tripped. Start up the computer for find "Reboot and select proper boot device..." message. So, apply the backed up image to the SSD since repairing the MBR didn't work.

Now this morning she comes in and the PC is running fine. Attempts to open Microsoft Word and she gets a pop-up stating there isn't enough disk space. So, she then restarts and upon booting back up gets "Reboot and select proper boot device..."

Any ideas what is causing this? Is it something with the mobo or do I just have horrible luck and replaced the bad SSD with another bad SSD?

 

Reboot and Select Proper Boot Device...after reboot?

cmos battery, or bios chip is screwed up

 

"reboot and select proper boot device" after fresh install

I understand your logic.
But that is not what is happening.
See.



It simply won't go.

On the other hand, if I take this path... brings me to W10 from where I'm posting *Smile