Windows 10: reinstall Realtek camera to Windows 10

reinstall windows 10 realtek Camera

:)

 

The Ultimate Realtek HD Audio Driver Mod for Windows 10

I had the realtek error when using the installer, so I did these step and It Worked

1.Go Open up device manager
2. Go under sound,video, and game controllers
3. Find Realtek High Definition Audio
4. Right click and hit update driver
5. Browse my computer for driver software
6. Let me pick from a list of available drivers on my computer
7. Click Have Disk and hit browse
8. Click on the Realtek HD Audio mod folder and look for win64
9. Click on the HDXRT4 and click ok,
10. Click Next and Yes
After it is done, restart the PC

You should be good then and also make sure before doing these steps that you have driver enforcement disabled.

 

The Ultimate Realtek HD Audio Driver Mod for Windows 10

Hey Dj Urko, I am trying to install the realtek driver and I get the error 0x0001. I have disabled secure boot and Driver signature. I have the latest win 10 build. What am I doing wrong? Can u post the complete list of steps that I have to take? I have an asus z170 with alc1150.
Thanks in advance

 

The Ultimate Realtek HD Audio Driver Mod for Windows 10

For those who just need to enable Dolby Digital Live 5.1 for your realtek sound card here is complete manual. Works for me in Win 10 Creators update (1703). Easy installation if you do not need these Dolby things just allow DDL 5.1

Here is the post #27
https://www.techpowerup.com/forums/...by-digital-live-dts-interactive.228612/page-2
and here is the link for Realtek R2.80 driver doownload (can not be found on Realtek official site)
MEGA

You also need to enable Test mode before installation of the driver.

Enable Test mode:

Step 1. Open the Windows command promt as "Run as Administrator".

Step 2. Run "bcdedit -set loadoptions DDISABLE_INTEGRITY_CHECKS" (without the "").

Step 3. To finalize the process run "bcdedit -set TESTSIGNING ON" (without the "").

Step 4. Reboot and you're done.

To disable it do step 1 and run these commands on step 2 and 3:

Step 2. "bcdedit -set loadoptions ENABLE_INTEGRITY_CHECKS" (without the "")

Step 3. "bcdedit -set TESTSIGNING OFF" (without the "")

Then do step 4 and you're done.

Then you can continue to installation of the driver.

I hope I helped you, if any questions, ask here I'll try to answer you if I'll be able.