Windows 10: Remote Desktop: only on same wifi channel?

I have a notebook computer that I use Remote Desktop to log into.
My router has a 2.4G radio, and two 5G radios.
If the notebook and computer I am using Remote Desktop on are both on the same radio, it works fine.
But if the notebook is on one radio and my computer is on another, it does not find the notebook (even though they are on the same router)
How can I fix this?

:)

 

remote desktop

Hello,



Thank you for writing to Microsoft Community Forums.



Please help me with the below details to understand your issue in a better way:

1. Are you using the Microsoft remote desktop app?
   

If you are using the Microsoft remote desktop app downloaded from
Microsoft store then, I suggest you to follow the steps to
fix problems with apps from Microsoft Store.



If the issue still persists with the Microsoft remote desktop app, then you can contact the support team by going to the

link and scrolling down to the bottom and clicking on
Microsoft remote desktop support under the Publisher info.



However, if you are using the Remote desktop connection, which comes pre-installed with Windows 10, then I suggest you to please post your question in the
TechNet forum.



Hope it helps.



Prakhar Khare

Microsoft Community - Moderator

 

Remote Desktop

Okay guys need some help here before going crazy...
I am trying to setup a remote desktop connection and see exactly what the logged on user is looking at with out going through Windows Remote Desktop.

Since its local network I don't have any password or want to setup a password.

Any suggestions are appreciated

 

Windows 10 - Remote Desktop

Hi,

We will surely assist you with the issue you are facing with Windows 10.
- Which version of Windows 10 Operating System are you using?

- Were you able to upgrade to Windows 10 successfully?

I suggest you to refer the below steps and see if this helps.

• 
  Enable remote desktop in settings
  
  • Control Panel\System and Security\System, Click "Remote Settings" on the left side
• 
  Verify my port forwarding settings were properly forwarding to my computers local IP address
  
  • run "cmd.exe" and then type "ipconfig". Find your IP from that list

[*]

• Make sure your firewall settings are open
• Go to "Control Panel\System and Security\Windows Firewall\Allowed apps"

• On the left, click "Allow an app or feature through Windows Firewall"
• Click "Change Settings"
• Find "Remote Desktop" in the list and make sure both "Private" and "Public" is checked.

Let us know if this helps.

Thank you.

Credits to : Jace_Sango.