Windows 10: Removed Device after factory reset, unable to activate Windows with Inbuilt hardware code

Hi, this is a mix between activation and me not understanding how devices work apparently. So I ran into a hard drive failure recently, which has led me to fully replacing my storage in my PC. Before my hard drive fully failed, I reinstalled Windows 10 to see if that was the current problem which it wasn't. When using the hardware Windows 10 activation code, it would not allow me most likely because Microsoft IDed it as a separate PC. After this, I was unable to activate Windows again, then my PCs hard drive failed and now I have a new one. The problem is I still have the code in my current hardware, as well as in an email I wrote to myself before it failed, but it will not work because Microsoft ID's it as a separate PC. I also no longer have my old PC in my devices as I removed it thinking that would remove the code's activation on the old PCs ID. Unfortunately I do not want to have to replace windows as it costs quite a bit for me right now.

:)

 

factory reset code

*Bang Head :banghead:i have a dgm LTV-2261WCR 22" DVD combi which i use as my monitor and tv, however since the visit of the ex's brat ive found the child lock is active. i need to retune the tv, as losing freeview channels rapidly, can ne1 help me with a factory reset/override code?

thanks in advance

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Radio Switch Device Error Code 19

Hi Kara,

Thank you for bringing up your query on Microsoft Community.

We sincerely regret for the inconvenience caused, and appreciate the steps you have taken so far to fix this issue.

The error code 19 describes that, Windows cannot start this hardware device because its configuration information (in the registry) is incomplete or damaged.

Recommended resolution

• Uninstall and reinstall the driver.
• Revert to the most recent successful registry configuration.
  

Before we could reset the computer to factory settings, I suggest you to refer to the below article and perform the troubleshooting steps suggested for error code 19.

Error codes in Device Manager in Windows.

https://support.microsoft.com/en-us/kb/310123#bookmark-19

Hope it helps.

Let us know the status, we are happy to assist you further.