Windows 10: Reparación automática en loop

Buenas. Cuando inicio la PC me queda en loop la reparación automática de Windows. Intenté con opciones avanzadas, pero me dice que tengo que poner la contraseña de la cuenta, la pongo y no me la reconoce, ya intenté cambiarla y tampoco la reconoce. Cómo puedo solucionarlo?

:)

 

Windows 10 endless loop reboot

Hi,

• Have you checked if the hard disk is set as first boot device in the BIOS?
• Which version of Windows is installed on the computer?
• What did the HP supported suggested you to fix the issue?

I suggest you to follow the steps provided in the following article and check if it helps.

Redirecting

If the issue persists, please get back to us with the more information about the interaction with HP support and the outcome of the issue.

 

Windows 10 restart loop

Hi,

To understand the issue better, I would like to ask some questions:

• What is the make and model of your computer?
• Do you get any error message?

I suggest you to follow the steps provided by Andre Da Costa from the link provided below and check if it helps.

Redirecting

Hope this helps. Keep us posted on the status for further assistance.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".