Windows 10: Reset failed and now computer is stuck

Hi there,Last night I tried to reset my computer but the reset failed. It got stuck at 18% for hours so I turned it off. When I turned it back on it displayed the following. “The computer restarted unexpectedly or encountered an unexpected error. Windows installation cannot proceed. To install Windows, click “OK” to restart the computer, and then restart the installation.” I pressed “OK” but it just restarted and went back to the same thing. Every time I press OK it just restarts and shows the same thing. If I could just access windows I could see what the problem is but it is just stuck. I tr

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Windows 10 fails to update


When you finish testing the Avast suggestion, make sure that you restart your machine.

Then if the issue persists, please return to the trouble shooting list in post# 89

I think there are three steps that remain; the WU troubleshooter, reset WU components, and manual WU reset.

 

Stuck in Windows 10 Upgrade

My computer seems to be stuck in a Windows 10 failed upgrade loop. I was running fine on a beta version of Windows 10, and then I came downstairs one morning to see it repeatedly booting, attempting to repair, then rebooting. The steps I've taken to diagnose are:

• Attempting to boot off a USB drive (with all drives disabled in BIOS) - this fails at the point of the blue windows screen
  
• Attempting to boot the machine itself and getting into "repair/safe mode" using F7
  
• Looking at the BIOS for obvious failures (e.g. RAM that should be there is missing) - nothing obvious is wrong.
  

I am fairly certain the build version was 9926. For many months, the system would attempt to upgrade, and then say "it failed" for some reason and roll back.

Suggestions for next steps?