Windows 10: Reset Input Device

I by mistake marked my input device as headset but it is a headphone, so while using it windows just turn off my in-PC microphone causing me problems.So how can i just reset it?

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Touchscreen unresponsive unless I remove the USB Input device driver

Hi Ben,

We want to know more about the issue that you're experiencing. Please provide us the following information:

• What USB input device are connected to your tablet when this issue with the touch screen is happening?
• What other troubleshooting steps have you done so far to fix this issue?
• Have you tried using your device without the USB input device?

Regards.

 

Touchscreen unresponsive unless I remove the USB Input device driver

Hi Ben,

Instead of uninstalling, we suggest disabling the "USB input device" listed in Human Interface Devices and check if it resolves the issue.

Let us know if you have any other questions.