Windows 10: Reset my PC now I have software from the acer on my dell. How do I return to the stuff my...

I have a dell inspiron 5675 or something and i made a recovery USB on my acer nitro 5 laptop. Now I have acer software such as nitrosense on my pc and would prefer either none of it, or the dell stuff I had before. How do I get them back?I assume I create a new recovery USB using dell USB recovery application for my pc and do another reset?https://www.dell.com/support/home/en-uk/drivers/osiso/recoverytool/wt64aHere.

:)

 

Returned the ASUS and purchased a Dell

I have made my decision and I am returning the Dell. After my money is refunded, I will have to do research and will have a choice on what to find that fits into my budget but better than the Dell. I hate returning things like this. It is so frustrating. I know a lot of you have recommended brands, models, and told me where to purchase a computer from, but if some of you could re-list some suggestions that would be very much appreciated. I need all of the help I can get with this.

 

Is there a software that can keep your pc clean, fix it etc

There is no single software application that can perform all of the desired steps.

There are multiple software that can perform steps but the unexpected can always happen.

These are some suggested software:

1) Run the Dell software to update drivers, software, and BIOS
2) Run the Dell diagnostics to check hardware
3) Run Ccleaner to clean (modify the boxes to specify what is and is not cleaned)
Use the software to clean windows and applications.
Don't use the tool to clean the registry.
4) Make a backup image in case there are unexpected problems

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".