Windows 10: reset pc and i think i still have malwhere

hi there, yesterday i had a virus on my pc and it almost broke my computer, i manged to reinstall windows but ive done some research and ive seen viruses and malwhere can stay on ur pc forever. sometimes on malwherebytes i keep getting PUP and a file keeps going into my opera gx cache, ive also got this issue on autoruns, windows defender is in red so i think malwhere could be tampering with virus and threat protection. have a look

:)

 

I THINK MY PC RESET IS FROZEN?

Hello,

To help you resolve your concern, we suggest that you follow the instructions below:

Power cycle your device. Here are the steps:

• Force shutdown your computer by pressing and holding the power button down for 5 to 10 seconds.
• Remove all the attached cables for 2 minutes then put them back on.

If the same thing happens, we suggest that you perform the reset again.

Let us know how it goes.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??