Windows 10: Reset pc deleting all files and connection issur

when I reset my pc completely reset delete files and everything it tells me I need to update and connect to the WiFi and if I press skip this step it restarts my pc but does absolutely nothing and sends me back to the screen and when I try to connect to my network it says we can’t connect right now so I’m in a endless loop any help is appreciated

:)

 

Reset Windows 10. Wipe all files?


Hello Wiss, and welcome to Ten Forums.

If you select all drives as step 6 below while doing a reset, it will delete all files from all drives connected to the PC.

Reset Windows 10

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Unable to delete a file

Hi Brent,

There are a lot of possible reason why the issue occurs, we suggest that you access
safe mode
and
delete the files there. If the same issue occur,
reboot
your PC and run these following
methods of troubleshooting
steps:

Method 1:
Run SFC Scan.  

To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Method 2:
Run DISM Tool.  

To run
DISM Tool, follow these steps:

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type the following command:  
  
  • 
    DISM.exe /Online /Cleanup-image /scanhealth  
    
  • 
    DISM.exe /Online /Cleanup-image /Restorehealth  
    

NOTE:
This might take a while to finish scanning.
Do not cancel. 

Method 3: Clean Boot.

To perform a
Clean Boot, click
here.

Note:
Reset the computer back to
Normal Mode
once you are done with the troubleshooting by following the section
"How to reset the computer to start normally after clean boot troubleshooting"
from the same article.

Let us know how it goes.

Regards.