Windows 10: Reset PC / Login.

If I reset my PC using the ‘Remove All’ option, will I have to log back into the Microsoft Account I made when I first bought the PC?

:)

 

Unable to login to the PC

Hi,



Thank you for writing to Microsoft Community Forums.



I understand how it feels when the PC doesn’t work the way it is supposed to. For further clarity on the issue, please respond to the questions below.

1. What is the error message you receive when you try to login to the PC?
   
2. Are you aware of any changes made to the PC prior to which you weren’t facing this issue?
   
3. Are you using a local account or a Microsoft account to login to the PC?
   

If you are using a Microsoft account then I would suggest you to try resetting the password of the PC and see if you are able to login. Refer the article

How to reset your Microsoft account password



If you are using a local account on the PC, then you can refer the article

Reset your Windows 10 local account password



Note: The article talks about resetting the PC. It is not advised to reset the PC if you don’t have the backup of the data.



You can also try booting the PC into safe mode and see if you are able to login. Refer the article

Start your PC in safe mode in Windows 10



If the issue persist, please get back to us with the results of the troubleshooting steps to assist you further.



Regards,

Prakhar Khare

Microsoft Community – Moderator

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Can't login to new computer w/Windows 10

Hi,

Thank you for your reply.

• 
  Are you able to login to Microsoft Account on Web?
  
• 
  Have you installed any language pack?
  

I suggest you to follow the steps below and check if it helps.

Step 1: I suggest you to select the appropriate language in login screen at the bottom right corner and check if it helps.

Steps 2: Use On-screen keyboard in the login screen to login and check if it helps.

Hope this helps. If the issue remains unresolved, please get back to us and we would be happy to help.