Windows 10: Reset this pc support

I recently upgraded my computer's graphics card, cpu, ram and added a new nvme 1tb ssd along with my cI wanted to perform a fresh reset of the system so I initially used windows 11 installation media from a external usb and it booted up fine. But now when i load up the system, it prompts me to choose which operating system to choose everytime , windows 10 or 11. So i thought i did not format it properly and decided to use the reset this pc option and clean all my other drives. But now it has been close to 3 hours and only 27% done, is that normal? Thank you so much

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

B3 Phenom support

I checked gigabyte's site on my GA-M57 and it didn't say anything about b3 stepping update, but all of the x3 chips are b3 steppings, so just use the x3 support bios if available.