Windows 10: Resetting this pc stuck at 19%!!! Help

My factory reset stuck at 19% for an hour now... What should I do?

:)

 

Resetting this PC stuck at 19%


Hey guys,

I've attempted a full reset of my laptop (Remove files and clean the drive). It has a 300GB hard drive.

Its now been stuck on the 'Resetting this PC' at 19% for the past 48 hours.

The hard drive light on the laptop is still blinking, so it looks like it is still doing something but i'm not sure if it is just stuck in a loop now.

Should i just hard reset it and repair or wait it out? (if so how long)
Also if i do the former, i still need to clean the drive as i'm selling the laptop..*Sad

 

Radio Switch Device Error Code 19

Hi Kara,

Thank you for bringing up your query on Microsoft Community.

We sincerely regret for the inconvenience caused, and appreciate the steps you have taken so far to fix this issue.

The error code 19 describes that, Windows cannot start this hardware device because its configuration information (in the registry) is incomplete or damaged.

Recommended resolution

• Uninstall and reinstall the driver.
• Revert to the most recent successful registry configuration.
  

Before we could reset the computer to factory settings, I suggest you to refer to the below article and perform the troubleshooting steps suggested for error code 19.

Error codes in Device Manager in Windows.

Error codes in Device Manager in Windows

Hope it helps.

Let us know the status, we are happy to assist you further.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".