Windows 10: "Restart to repair drive errors" not solved even after chkdsk

After installing an update on 01/11 can't rmb what the update was and not very sure if this was the cause, I've been receiving the "Restart to repair drive errors" and having chkdsk start whenever I switch on my laptop. Windows says that they found errors on my C drive see img below but however many times i run the chkdsk and restart my laptop, the issue persists.I've also tried to run sfc /scannow however no errors were found. Also downloaded the SanDisk Dashboard and it states that my hard disk is fine. Very confused as to what to do right now because i've flipped the entire internet ups

:)

 

"Restart to fix drive errors" shows up after reboot, CHKDSK says otherwise

Hi,

There are several reasons why this issue occurred. If chkdsk did not found any errors, we suggest following the steps provided by Smittychat on this
thread on how to use the command-line utility as another workaround.

Update us with the outcome so we can provide further assistance.

 

repairing drive c

The part of process that you are in when updating Windows is the check disk (CHKDSK), the system is checking your drive for errors.

Are you still having the issue and stuck at Scanning and repairing drive process?

As a workaround, you can follow these steps to bypass the CHKDSK process:

• Hold down the power button for 4 seconds.
• The PC will reboot.
• You will get stuck again on the process, repeat step 1.
• You will get a message "press any key to bypass the chkdsk."
• Press any key and it will continue on the update process.

Let us know if you need further assistance.

 

chkdsk c: /F

It might be an error on the drive. We suggests that you follow the troubleshooting steps below:

• Run Disk Cleanup utility to clear your junk files.
• Open an elevated CMD type sfc /scannow and hit Enter to run the System File Checker.
  
• Once the scan is completed, restart your computer. Remember to exit ChkDsk
  during boot.
• Next, again open CMD as admin type
  Dism /Online /Cleanup-Image /RestoreHealth and hit Enter to repair the Windows image.
• Now see if ChkDsk able to complete the scan.

Note: Before doing the steps, make sure you save a back up of your files.

Let us know how it goes.