Windows 10: Router login page not working

Router login page not working...
pics...



:)

 

Why Netgear Router Login Page not Working?

Can anyone please suggest that why is my Netgear Router Login Page routerlogin.net not working? I tried to access this webpage with the default IP address 192.168.0.1
and 192.168.1.1 but i am unable to access the login page of Netgear Router. Please help.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Can't access router config page 192.168.1.1

Sorry, but that will only work for Netgear routers.

Default URLs for well known routers' control panel home page:

• 3Com - http://192.168.1.1
• Linksys - http://192.168.1.1
• D-Link - http://192.168.1.1
• Belkin - http://192.168.2.1
• Netgear - http://192.168.0.1
• Micromax - http://192.168.10.1
• BT Home Hub - http://192.168.1.254

Apologies if you've tried all the suggestions below.

• Make sure that your router is plugged into an active power source.
• Make sure that the device that you are using to access your router's interface is connected to your router's network.
• If you're having trouble connecting to your router's network through WiFi, try using an Ethernet cable.
• If you changed your router's default IP address, enter your new IP address instead of the default IP addresses.
• Some firewalls and popup blockers stop JavaScript from running. If your router web interface uses JavaScript, you might need to temporarily disable your firewalls and popup blockers while you access your router's interface.
• If your web browser cache is full, you might need to clear it.