Windows 10: safe boot breaking my pc

whenever I go into bios and turn on safe boot and click save my pc doesn't work, all the fans are on but the rgb on my CPU fan is bearly working. the rgb on my keyboard and mouse don't turn on. when i reset my bios then my pc works perfectly fine but if I want to play the game I want to play safe boot is a requirement to run the game. what am I supposed to do about this?specs:gigabyte 1660 overclocked ryzen 7 5700x570x aorus elite wifi32 gb ram1t m.2

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

PC shows Automatic Repair screen after booting

Hi,

Thank you for replying.

Refer the steps mentioned below to restart the computer in Safe Mode:

1. On the Choose an option screen, click on Troubleshoot.
2. Click on Advanced options.
3. Click on StartupSettings and click on
   Restart.
4. After the device restarts, you will see list of options. Select option
   5 or press F5 to boot the computer into
   Safe Mode with Networking.
   

After restarting the computer in Safe mode, refer the steps mentioned in my earlier response to perform clean boot and see if the PC boots normally.

If the computer doesn't boot,
I would also suggest you to refer the troubleshooting steps mentioned in the section
Use installation media to restore your PC from the article
Recovery options in Windows 10.

Let us know how it goes.

Regards,

Nikhar Khare

Microsoft Community - Moderator

 

Windows 10 Pro and Ergnomic Break Reminder

Hi,



Apologies for the late reply.



Do you remember installing any break reminder software?



It looks like it is a pop up from a break reminder software.



I suggest you to look for this in Programs in features and uninstall it if do not use it.



Try the following steps:

• 
  Press Windows + R keys to open Run Command
  
• 
  Type Appwiz.cpl and hit enter
  
• 
  Search for the programs and un-install it.
  

Regards,