Windows 10: Scanner issues

I have an HP 7720 all in one and have been using it for several years. Scanned OK yesterday - went to scan today and its telling me it is not compatible with the same computer. Switched both off and re-booted. Same message. Would appreciate any help please

:)

 

Microtek scanner on Win 10 Pro

Hi Jean,

To get better clarity on the issue, kindly answer the questions below:

• Is the scanner detected under Devices?
• Were you able to see the scanner on the Device Manager?
• Have you installed the latest driver for the scanner?

We suggest you to run the troubleshooter for hardware and devices. To do this, follow the steps:

• On the Start menu, type Troubleshooting and hit enter.
• Choose Hardware and Sound.
• Select Hardware and Devices and run the troubleshooter.

If issue persists, we suggest you contact the manufacturer to get better assistance.

Do let us know if you need further assistance.

 

Fingerprint Scanner Not Working

Hello Gary,



Thank you for posting on Microsoft Community.

To resolve this issue try the following steps:

• 
  Have you updated the driver for the Finger Print scanner? If not, check on the manufacturer’s website (HP).
  
• 
  Check if installing the latest driver of the fingerprint scanner allows you to login using a Microsoft Account?
  

This issue might occur due to driver incompatibility since upgrading to Windows 10.



If you have the raw executable file of the corresponding driver for the validity sensor, I would suggest you to install the downloaded driver file in compatible mode with Windows 7 or 8. Refer to the following steps to do so.

• 
  Right click on the driver, and click on Properties.
  
• 
  Go to the Compatibility tab.
  
• 
  Check the box for Run this program in compatibility mode for:
  
• 
  Select Windows 7 in the list of Operating systems.
  
• 
  Click OK.
  
• 
  Double-click the driver file to install the driver and follow the onscreen instructions.
  
• 
  Reboot your computer.
  

Hope the above steps help.



Thank you.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.