Windows 10: "Scanning and repairing drive C:: 100% complete" Error!

I have this nagging problem with Win 11 Pro showing "trying to fix my C drive during bootup, just because "lights went off". From that moment on i started to seethe Repairing error during boot time.So it is commonly thought it could be a disk error.So the solution would be to chkdsk c chkdsk c d: and e: or chkdsk /f /r .Used this command in Safemode:chkdsk c /f /v /r /xchkdsk d: /f /v /r /xchkdsk e: /f /v /r /x Still the same errorAlso i am using Eazy Fix for instant data recovery. But the error keeps showing if i boot to any snapshot.I was quite dissapointed when this happened.This i

:)

 

Stuck repairing and scanning c drive 100% complete

On start up my computer says scanning and repairing drive c 100 % complete but appears stuck

 

Scanning and Repairing Drive C 100% Complete - STUCK

OK... I went in and checked the results of a CHKDSK. The only thing that I could see that was puzzling was that I saw this:

WARNING! /F parameter not specified.

So I did this check...





F: is a DVD drive as is E:

You can see that they come up differently and I'm not sure why a DVD drive would come up as NTFS.

Could the CHKDSK be hanging up due to CHKDSK seeing the F: as NTFS?

My Computer shows it correctly:





I went into Computer Management and everything looks good too.




--------------------------------

I ran Macrorit Diskscanner on my c: and it came back as fine, no damage. (100% good)

The only issue that I know about my c: is that when I first purchased it, it had 1 bad block. When I contacted the manufacturer, they stated that 1 bad block is OK. I have had the SSD for a few years now and never had an issue with it. the bad block does come up in Acronis Drive Monitor under Reallocated Sectors Count as Degradation, but the health is good at 98%.

I did check the drive in CrystalDiskInfo as you requested and here is a screen shot:






BTW, I appreciate that you are trying to help me figure this out. When my computer has issues, it bugs the crap out of me until I can figure out how to resolve the issue. So, thank you.

 

Scanning and Repairing Drive C 100% Complete - STUCK

When my computer does a chkdsk /r, and restarts, the scan will get stuck on 100%. I've let it sit for over 16 hours and it stays stuck. If I hit the reset button, it''ll restart, the Scanning and Repairing Drive C 100% Complete momentarily comes up, but then it moves forward and boots up to my desktop. I see this is a known problem and have tried several different so called solutions I've found on the internet to no avail. Can anyone help me?