Windows 10: services are stopped in system config. Is this a problem?

Services are stopped in system config is this a problem

:)

 

Windows 10 1709 System Restore problems...


That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.

 

Windows 10 error: "Windows couldn't connect to the Group Policy Client service. Please consult your system administrator"

Hi Rico,

Thank you for posting in Microsoft Community, we appreciate your interest in Windows 10.

I understand the inconvenience you are facing with accessing the operating system.

Do let us know the following to assist you better:

• Which edition of Windows Operating System are you using?
• What all the troubleshooting steps have you performed?
• Have you installed all the pending updates on your Operating System?
• Have you installed any third-party anti-virus software on your system?

I suggest you to try few of the below troubleshooting steps and check if it helps.

I suggest you to Stop the Group Policy service, restart and set it to Automatic.

Group Policy Client service, this service is responsible for applying settings configured by administrators for the computers and users through the Group Policy component. If the service
is disabled the settings will be applied and applications and components will not be manageable through Group Policy.

Step 1: Stop the Group Policy Client service.

• Press Windows Key + R on the keyboard and type
  services.msc, Services window gets opened.
• Search for Group Policy Client service, right click on it and click on
  Stop.
• Restart the computer.

Step 2: Start the service and set it to automatic:

• Press Windows Key + R on the keyboard and type
  services.msc, Services window gets opened.
• Search for Group Policy Client service, right click on it and click on
  Properties.
• Start the service, set
  Startup type to Automatic.

Hope it helps. Reply to the post with an updated status of this issue for further assistance.

 

stop code,,,, bad system config file

After a windows 10 update, my system wont start, I get the bad system config file error, I have let the automatic repairs run several times, I have tried all the different options for restarting the unit, I have chosen restore points that come up in the
restore point list, I have tried to restore to them but it always gives a failure notification and stops the procedure, how do I get a windows 10 boot device since it has all been done via the internet?