Windows 10: Settings App crashes when I open properties of my connected network.

Refer to the image attached in the imgur link.https://imgur.com/a/6E8x03DWhen i click the i button on top right the settings app opens for fraction of a second and crashes.I have tried reinstalling AX211 driver and network reset but the problem persists.Any help would be greatly appreciated.

:)

 

Set Broadband Internet Connection Network Configuration

Hi,

Upon analyzing the details you have provided, kindly run the
Network and Internet Troubleshooter
and check if there's any changes. To run the
troubleshooter,
follow these steps:

• 
  On the search bar, type
  Troubleshooting.
  
• 
  Choose
  Network and Internet.
  
• 
  Run the following
  Troubleshooter:
  
  • 
    Internet Connections.
    
  • 
    Network Adapter.
    
  • 
    Incoming Connections.
    

If the issue persists, we suggest that you try to
renew
your
IP address. To do this, follow these steps:

• 
  Open
  Command Prompt
  as
  Administrator.
  
• 
  Type the following command:
  
  • 
    Ipconfig/release
    and hit
    Enter.
    
  • 
    Ipconfig/renew
    and hit
    Enter.
    
  • 
    Exit.
    

Let us know how it goes.

Regards.

 

VPN Connection - Cannot open Networking Properties IPv4


We use a lot of VPN PPTP Connections. On most we turn off "Use default gateway on remote network". See the image below that shows where this setting is turned off.

We cannot open the properties for Internet Protocol Version 4 on VPN connections under Windows 10. This is located at Network Connections and Properties of a VPN Connection. Networking Tab, then select Internet Protocol Version 4 and click Properties. But under Win 10 the properties dialog does not open.

This has been tested on several Windows 10 systems and we have enabled Administrator and tested under that login as well.

 

Missing field Connect using in Local Area Connection Properties

Have you tried uninstalling the Network Adapter? Since there is no properties in the Local Area Connection, we suggest that you uninstall the Network Adapter. Follow the steps below:

• Press Windows Key + R.
• Type devmgmt.msc.
• Right click on the Network Adapter.
• Select Uninstall.
• Select Ok.
• Select Scan for Hardware changes.

Update us on the results.