Windows 10: Settings reset after every restart

For some time now my setting have been reset every time i power on my compuer. The main thing is my mouse settings. Every time i turn on the computer "Enhance pointer presicion" gets checked. The Pointer speed also get higher every time. Sometimes the vertical scrolling number changes as well, up to 99 instead of 2 which i usually have it set to. Lastly it sometimes changes my audio output to my monitor speakers instead of my headphones.I change the settings back every time and i click apply but it still does not save propertly. The pointer speed can also not be set to what it was before i got

:)

 

Windows 10 infinite restart black screen

Thank you john for all of your help i decided to get the usb my computer came with and factory reset it i didnt have anything that personal or valueable so its ok thanks for the help though i appreciate it

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.