Windows 10: SFC SCANNOW always repairs corrupted files and Windows update at restart, repeatedly

sfc /scannow always finds corrupted files and successfully repairs them, but at every restart there is windows update running. This process happens recursively. I opt to do sfc /scannow since I had BSOD related to PAGE FAULT IN NONPAGED AREA caused by dxgmms2.sys while playing Alan Wake 2 and for which I have tried updating and rolling back graphic drivers, but no solved so far.

:)

 

MBR keeps corrupting after restart

I have a machine that when restarted or allowed to go into hibernation, I receive a missing/corrupted master boot record message and Windows doesn't boot. I am able to successfully repair the MBR each time using Windows recovery console, but I'm unable to determine what keeps making it happen.

Dell Latitude E6420
Windows 7 64bit

Steps performed so far: -besides fixing the MBR after each restart or hibernation
-ran system file checker sfc /scannow
-ran chkdsk
-verified that ACHI was enabled in the bios

If I can't figure this out I will end up just reinstalling the operating system, but I worried that the issue with just reoccur later down the line. Any advice/recommendations would be much appreciated.

 

SFC scannow not working but verify only is working

there is no problem in chkdsk I've checked When I select command prompt and sfc scannow from f8 and repair.. it shows that a reboot is required for pending repair and pending renames folder in winsxs is full of files.. what should I do??

 

Need a file from Windows 7

Have you tried sfc /scannow? It is supposed to find and repair corrupted operating system files.