Windows 10: SFC /SCANNOW Question

Just got a Windows Update. Build 17134.285. After everything installed and updated, I ran sfc /scannow and it said I had corrupted files it could not fix. Use the log created do an online repair? So there is a way to fix the file corruption without re-installing Windows?

:)

 

SFC scannow not working but verify only is working

there is no problem in chkdsk I've checked When I select command prompt and sfc scannow from f8 and repair.. it shows that a reboot is required for pending repair and pending renames folder in winsxs is full of files.. what should I do??

 

SFC /SCANNOW Errors After Update


I've just updated a Windows 8.1 Pro PC to Windows 10 using the Techbench ISO which updated without any problems. However, I've just run sfc /scannow and it found errors it could not repair. I have managed to get sfc /scannow to run without errors - see what I did below:

1. Ran sfc /scannow which showed error "Windows Resource Protection found corrupt files but was unable to fix some of them."
2. Ran Dism /Online /Cleanup-Image /ScanHealth which reported "The component store is repairable."
3. Ran Dism /Online /Cleanup-Image /RestoreHealth which failed with Error: 0x800f081f "The source files could not be found.Use the "Source" option to specify the location of the files that are required to restore the feature."
4. Mounted the W10 Techbench ISO and ran Dism /Online /Cleanup-Image /RestoreHealth /source:wim:G:\sources\install.wim:1 /limitaccess which reported successfully "The restore operation completed successfully."
5. Ran sfc /scannow wich completed successfully with report "Windows Resource Protection found corrupt files and successfully repaired them."

Please advise:

1. Why would sfc /scannow fail on a newly updated installation which ran sfc /scannow error free immediately before the upgrade?
2. Why did I have to use install.wim from the Techbench ISO at step 4 above for Dism /Online /Cleanup-Image /RestoreHealth to work and will I have to use install.wim from the Techbench ISO every time I need to run this Dism command?
3. How can I configure my PC so it has the correct install.wim file for the Dism command to work properly?

 

sfc /scannow errors


Important thing to remember is that the SFC / SCANNOW cannot always fix all errors at once. It is quite often required to run SFC /SCANNOW several times.

I have often had a situation that only a third, fourth or fifth run has finally reported "No more errors".

This is how it should be done:

• SFC / SCANNOW
• If SFC reports not all errors were fixed, reboot and run it again
• SFC / SCANNOW
• If SFC again reports not all errors were fixed, reboot and run it again
• And so on

Screenshot from the TenForums SFC tutorial: