Windows 10: Sharing: HOW do I stop this? A setting has changed and I don't know why or how to change it...

I noticed just today happened within a day some sharing setting and because I did not do it, and never saw it before, I am at a loss how to get it back. The photo I took, it was a screen shot, now has a little box on the upper left that says, "see all photos." It NEVER said that before. I fear if I upload this to an email to send to someone it will show ever damn photo in my notebook. I am now in fear that will be the case with my docuyments. this is my private notebook computer. I don't share with anyone else, I don't use it for anything but personal stuff and I am 1 at a loss as to how th

:)

 

How to stop sharing folder for windows 10?

Referring to following link, I would like to know on how to stop sharing folder for windows 10.

I cannot find Stop Sharing option on step 5.

Use these steps to stop sharing any folder on Windows 10:

1. Open Start.
   
2. Search for Computer Management and click the top result to open the experience.
   
3. Expand the Shared Folders branch from the left pane.
   
4. Click the Shares item.
   
5. Right-click the folder that you no longer want to share and the Stop Sharing option.
   

Furthermore, ADMIN$ is found to be Remote Admin under computer management.

There is no option to stop it as well.

Does anyone have any suggestions on how to stop sharing and remote?

Thanks in advance for any suggestions

How to stop sharing network folder on Windows 10 • Pureinfotech

 

I can't get text messages. & Also don`t change my account password

Dear Sir,

I can't get text messages for a verification code & also don`t know about recovery code. & Also don`t Change my account password please guide us.

Thanking & Regards

m.Sameem

 

Instructions to change board?

Boot off of the windows CD, repair your XP partition (hopefully you won't have to reinstall windows), install drivers, and you're good to go. You'll see dual channel mode in the BIOS splash screen results from POST. It'll be pretty obvious *Stick Out Tongue . Here's a list of general tweaks for the 939Dual-SATA2.
Step one- Set time, date
Step two- In CPU settings, disable cool n quiet, set memory clock to DDR400, play with memory timings (CAS-TRAS-TRP-TRCD), which are listed in the bios in the order CAS, TRCD, TRAS, and TRP. EDIT- new BIOS's mess around with this order, can't be too sure on it, but yeah at least you know what the RAM timings stand for *Big Grin .
Leave MA timing at 2T unless you think your system can handle 1T
Step three- in Chipset settings, enable onboard LAN, disable onboard Audio, disable AGP fast write, set primary graphics adapter, and set CPU-NB and NB-SB link speed to 1000mhz.
Step four- in IDE, disable controllers you aren't using. On all drives detected, enable SMART if you can and set PIO/DMA as high as they will go.
Step five- Enable legacy USB support
Step six- Set password if you're worried about anyone screwing around with your BIOS settings
Step seven- Configure your boot sequence. I reccomend hard drive first, optical drive second, and floppy drive third.
Step eight- Save changes, boot into XP, and enjoy your computer.