Windows 10: Shortcut to Print3D executable cannot find DLL files

I created a shortcut to the Print3D executable, but it does not work. I get error messages indicating that four DLL files cannot be located. I found that I get the same error if I double-click on the executable icon. The only way that I can run the Print3D program is from the Start menu. Is there a way for me to create a shortcut that will work?

:)

 

dll file not found after Creator's Update, Code Execution Cannot Proceed

Hi Aberfoyle,

It is possible that the
.dll file was corrupted during the update causing the error to occur.
To better assist you, kindly find the
.dll file
in
c:\Windows\System32. If you can find the
.dll file, it means that we need to
register
your
.dll file
to your
Operating System
for it to
work. To do this, we need to
unregister
the
.dll file
first and
re-register
it. Here are the steps on how to do so:

To unregister the .dll file:

• 
  Press
  Windows key + R, type
  Regsvr32 /u c:\Windows\System32\VCRUNTIME140.dll
  and hit
  Enter/OK.
  

To re-register the .dll file:

• 
  Press
  Windows key + R, type
  Regsvr32 c:\Windows\System32\VCRUNTIME140.dll
  and hit
  Enter/OK.
  

If you cannot find the
.dll
file in
c:\Windows\System32,
kindly run these methods of troubleshooting
so that we will know if the issue is within/not within the
Operating System:

Method 1:
Run SFC Scan.  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Note:
Kindly run
SFC twice or thrice
and check for results before you proceed to the next method.

Method 2: Clean Boot.

Clean Boot
will
stop or disable
the
applications
that are running in your
computer's background.
To perform a
Clean Boot, click
here.

Note:
Reset the computer back to
Normal Mode
once you are done with the troubleshooting by following the section
"How to reset the computer to start normally after clean boot troubleshooting"
from the same article.

After performing these
methods of troubleshooting
and still the issue persists, we suggest that you contact your
computer/laptop manufacturer
for further assistance.

Update us on how it goes.

Regards.

 

*.dll files associated with other file in Windows7

Yes the icon. No instability noticed at all, however I still can't get my "gadgets" to work, and they have a .dll file.

 

Prompt to execute shortcut


This time, for once, I actually want an "Are you sure . . ." window to pop up when executing a shortcut. Any suggestions?