Windows 10: Simple question about networking with Windows10

Hi all,

this is the first time I write here, so I hope non to be offtopic.

At home I have a small LAN to which are connected five PCs: three of them are Windows11 and two Windows 10. These PCs have some folders shared on the LAN that I use to copy or move files from one PC to another.

I would like to configure one Windows10 PC in a way that it wasn't detectable by all the other PCs, but only by one of them.

Does someone know if this is possible?

Thanks in advance.

submitted by /u/RioMetal
[link] [comments]

:)

 

Help needed with simple wired network

Step one- Connect all PC's to router, and then the router to the modem. PC's go to router by the ports labeled "1-4" on the back of the router. WAN port goes to router. Power up all network equipment, and then systems.
Step two- Power on the computer connected to port one. Go into router settings at 192.168.0.1 and configure internet, dyndns, firewall, etc.
Step three- Go to "network set up wizard" in windows. (Network places- network set up wizard). The rest is self explanatory.
Step four- right click on each drive and printer you want to share, and then configure sharing preferences. Should be easy enough.
Step five- right click my computer, and the select "map network drive". Using the network address for each piece of hardware you shared, assign network drive letters.

Congratulations, you have a fully operational network. Happy Gaming! *Toast :toast:

 

Help needed with simple wired network

Perfecto!!!! *Smile

 

Did our Epson printer get hacked?

Another question, is this on a home network or a work network? The steps @eidairaman1 listed are always a good first step. If this is on a work network you manage, I'd be much more concerned than the home one. It is possible someone is screwing with you, but malware could also be the culprit.