Windows 10: Slow map options on primary disk, other than windows C drive

Dear people,

I have recently upgraded my hardware. To 3 ssd. Gen 3 4x m. 2 slot nvme Gen 2 4x m. 2 slot nvme And sata 6gbs ssd. Manufacturers probably not important. Now is the case that I use a lot 'right klik' - to gain RSI for my hand- and for the map options to creat a folder and prospect content. This goes fast on the C drive where my windows is situated on. But on al the other it does not. Problem: right klik in folder takes 1 to 2 second to load, or more. Which is super annoying, while spending lot lf time klicking. For creating new folder, and like wise thinks. I would if anyone have this same difference in performance on their pc? Specifically between windows c drive and other drives. My Disks are healthy, trim on, and power settings are on performances mode. Im really looking forward to teackel this issue.

Thanks in advance Gr Sam

submitted by /u/No_Speed_439
[link] [comments]

:)

 

C: Drive disk cleanup

I've already done your suggestions....... yep, need a bigger drive for C: suppose!

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that

 

GPT disk conversion for both data drives and C drive


Macrium Rescue disk can be used to convert from MBR to GPT and vice versa without doing a fresh install of Windows.

1. Download Rescue6.1.1081X64.iso - Google Drive and use Rufus to create a bootable USB disk. Skip this step if you've already created the Macrium Rescue disk.
2. Download: BootEFI_Only-00-00.zip - Google Drive . Unzip to an external or an internal HD
   NOTE: This is a copy of the first 3 partitions of my current Windows 10 x64 (450MB Recovery, 100MB EFI and 16MB MSR)
3. Boot up Macrium Rescue disk and create a backup of your current Windows to another internal/external HD. It serves 2 purposes: you'd have a backup of your current Windows in case things go wrong and then use it to restore the C drive on the next steps.
4. Next, switch the BIOS to UEFI and use Macrium to restore the first 3 partitions downloaded in step 2 to your current MBR Windows. No need to convert or Format, Macrium will do it.
5. Again with Macrium, select the backup image from step 3, and copy back the C drive after the 3 partitions.
   After this step, you should have: 450MB, 100MB, 16MB and C drive (GPT partition scheme)
6. From Macrium, click on Fix the Windows Boot Problems
7. Reboot. Your Windows should be in UEFI mode.