Windows 10: So tried a factory reset and got past smog the percentage and everything was going ok until...

I have a Lenovo legion gen 7 with an RTX 3060 and a Ryzen 7 5000 series.

submitted by /u/Eljpenepe05
[link] [comments]

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Help with heat sink thermal paste for h100i 1800x

Use the paste you brought. Also I would have suggest artic x4 unless yours is better but yes use yours.

Actually check the temp with the factory standard factory paste first and list the temps

 

Windows 10 factory reset

Hi Charlie,

We can see here that you are having issues with doing a factory reset on your Windows 10. There are several factors
why you get the said error and that's what we are going to figure out. To isolate this concern, may we know the following:

• Any changes made on the computer prior to this concern?
• What troubleshooting steps have you tried so far?
  
• May we know the reason why you want to perform a factory reset?
• Did you experience any issues on the computer before you tried performing a factory reset?