Windows 10: SSD Change caused device failure

I switched out my SSD today due to its predicted failure after a SMART scan. I reinstalled windows through a USB onto my new SSD. However, when windows runs, both my graphics card and my wireless wifi adapter aren’t detected. When I check device manager, this shows up:

:)

 

SSD Failure


Last year I replaced an aging hard drive in my Mum's pc with a slightly less aging OCZ Vertex 2 SSD.

This morning she was using the pc just fine then left it until this evening when it suddenly would not boot and reported sata drive failure.

Perhaps I shouldn't be too disappointed considering it was last generation technology.

What should be my first steps in diagnosing this fault? If the drive has failed I may as well suggest it be replaced with a more modern one which I'm sure has better longevity. I have an external drive reader which can take any sata device. This should allow me to see if the data is accessible.

In my own rig I have a Samsung 840 EVO 250 which has served me well so I may suggest she gets the same unless you guys have alternative suggestions.

 

SSD Failure

Your SSD failed could be any number of things first I would re seat all cables on the drive. Second substitute another drive in the system and see if it shows up in BIOS or try the original drive in a another machine and see if the system can see the drive. The sata controller could also be bad on the mother board in that case no drive will work.

 

Taskbar bug: switching to another window -will not appear at the front


Follow either of these steps to fix the issue with the Active window hiding behind.

Method 1:
I suggest you to disable window by hovering over it with the mouse and check if it helps. To do so I suggest you to try the below given steps and check if it helps:

1. Press Windows key + X key and click on Control Panel.
2. Select or click Ease of Access.
3. Click or tap onEase of Access Centre.
4. Click on Make the Mouse Easier to Use was uncheck Activate Window by hovering over it with the mouse.
5. Check if issue is resolved.

Method 2:
I would suggest you to completely uninstall the touchpad driver and reinstall it. Kindly follow the below given steps.

1. Press “Windows key + X” and click on “Device Manager”.
2. In the list of devices, you should see the touchpad drivers.
3. Right click on the device and then select "Uninstall".
4. In the uninstall dialog, make sure you select the option to delete the driver package from the system. This causes the driver package installed earlier to be deleted.
5. In the Action menu of Device manager, select “Scan for Hardware changes” option. This will cause the device driver to be reinstalled. Once the driver is installed, close all windows and restart the computer.