Windows 10: SSD drive card help

Hi! I'm hoping to get additional storage by using an SSD drive on my hp laptop but the model hp laptop 15-fc0xxx doesn't have a slot. Could I use an sdd adapter? and if so, which adapter and SSD drives are compatible with the laptop? Thanks!

:)

 

Cloning to SSD then swapping drive letters


@SamHobbs
What you want done is very simple and can be done in short period of time. Here's my suggestion:
There's 2 modes that Windows can be installed: UEFI and the old legacy MBR. Open Disk Management, look at the disk where your C drive is, if there's a

1. EFI System Partition, your Windows was installed using UEFI.
2. System Reserved partition, your Windows was installed using MBR

Next, Connect your SSD to an available Sata port (no need to format or do anything). Download: Macrium Reflect Free . Install and run. Follow the steps below:

1. From Macrium, click on image this disk under your C drive and save it to either an Internal or External Drive. This will create a single backup image of the whole disk containing your C drive.
2. Again, from Macrium, click on Restore tab and select the image created from step 1, Select your SSD as the destination drive, click Next->Finish
3. Exit Macrium. If your Windows was installed using MBR, Open disk management and make sure the SSD is marked "Active" else go to next step.
4. Shutdown your PC. Disconnect the HD containing Windows C drive then connect your SSD to it.
5. Reboot. Your PC should boot and the Windows should have C as the drive letter.

NOTE: The procedure above is to backup your Windows to an image file then copy it back to the SSD. This ensures proper cluster size aligment for the SSD. In addition, Macrium also perform Trimming for the SSD. This is more preferable than cloning.

 

Windows 10 can not optimize HDD, says it is a SSD Help

Hi Steve,

Thank you for posting your question in the Microsoft Community.

Appreciate your efforts to work on this issue.

• Does the BIOS recognizes the disk as HDD or SSD?
  

Suggest you to set the Optimize Drives Service to start automatically from the services window to check if that helps.

1. Open the run window, type ‘services.msc’ and press Enter.
   
2. Search for Optimize Drives Service and select the start-up type as automatic. Also ensure to start the service.
   

If you have set SATA controller to AHCI mode for Solid State Drive, in Device Manager it would show as SATA hard disk.

Follow these steps:

1. Click start, type “Defragment” and click “Defragment and Optimize your drives”.
   
2. On the “Defragment and Optimize your drives” window. Make sure that your SSD is categorized as an SSD.
   
3. If it’s not, then you can set it as a SSD on your bios. This way, you don’t have to exclude your SSD or disable any scheduled defragmentation.
   

Disclaimer: Modifying BIOS/ complementary metal oxide semiconductor (CMOS) settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee that any problems resulting from the configuring
of BIOS/CMOS settings can be solved. Modifications of the settings are at your own risk.

Hope this helps.

Let us know if you got the help you needed.

Regards,

Srimadhwa B

Microsoft Community-Moderator

 

2 x SSD Raid 0 - is this right?

Hey Fits

Can you list a few helpful hints for T ski ,maybe a step by step how to OR what to look out for*Cool