Windows 10: SSD: Insane Amount of Writes in the Past 4 Days

Is there anyway to monitor what is being written on the SSD? For the past 4 days, I've noticed 69gb has been written onto the SSD, I only have programs and Windows installed onto the SSD.

The only programs that I use often are Firefox and Photoshop.

:)

 

Insanely slow HDD random read/write

I'm playing tech support for a relative, and her (ASUS K53E) laptop SATA HDD has insanely slow random read/write. Sequential r/w is around 74 MB/s, which seems fine, but random is around 1 MB/s. Hard disk health is fine according to S.M.A.R.T. Win10 1709 Pro x64. Pentium B960; HM65 Express chipset using the Microsoft Standard SATA AHCI Controller driver. Windows update doesn't have any driver updates; Intel driver tool returns nothing; Asus website has no Windows 10 drivers. I'm at a loss, any suggestions?

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Difficulties installing a new SSD

Hi RalphBrands,

Thank you for reaching back. I am sorry to hear that the steps didn't work for you. Let's try the following steps to see if this solves the issue.

It's possible that the drive has write protection, (If the drive has write protection, we can't do changes to it.) we can try to remove it by running these commands:

1) Press the Win+R keys on your keyboard to open the Run box.

2) Type diskpart -> press Enter to run it.

3) Inside the diskpart environment -> type and run each of these commands by pressing Enter.

4) Type list disk -> press Enter.

5) Identify your SSD in the list -> type select disk X -> press Enter (where X is the name of your SSD).

6) Run the command attributes disk clear readonly.

7) Wait for the process to complete

Next is to attempt to format your new SSD inside Diskpart

Run the commands in order below:

1) list disk

2) select disk n (n is the disk number you wish to format)

3) clean

4) create partition primary

5) format fs=ntfs quick

6) assign letter=x (x is the drive letter you wish the assign for the drive)

Hope this helps. Let me know so I can further assist you. Have a great day!