Windows 10: SSD not working.

I recently bought a Wd SSD 1 terabyte drive because the main drive was about filled. I cloned the main drive to my WD drive and used it as the main boot drive. It worked fine until one day while accessing the internet I got a blue screen that said recovery at the top and device not working . I did a reinstall of windows after removing the new SSD. The laptop worked and I reinstalled the SSD but it is not recognized in bios device manager or under disk drives. I connected it with a usb drive and it would not be recognized. I tried on another computer and no luck there either. It has all my

:)

 

Windows 10 infinite restart black screen


The tutorials provided are just a list of troubleshooting steps. Use only the steps which apply to you.

Since none of the troubleshooting steps here worked, I'd suggest you do a Clean install.

John

 

SSD Crucial Bx 100 - rattling/vibrating. Possible?

This has been suggested several times already, and it has been suggested you try to move the SSD, remove it, or even suspend it in your case. Will you please try one of these?

If you don't understand vibration and resonance, please refer to @dorsetknob 's post above. *Smile It has been explained that something else moving/vibrating (even if you don't think they're vibrating they are...), fans, hard disk drives, and anything with a motor will cause some form of vibration at certain frequencies. This can be transfered through your case's chassis and where you mounted your SSD could be reaching a certain frequency that causes it to slightly move and rattle against the case.

We are suggesting you take action and report back..you keep asking questions from step 1...we should be on step 4 by now...that is solution.

Try what has been suggested and report back please. Otherwise all you're doing is leading this thread in an endless circle and the help will stop shortly thereafter.

*Toast :toast:

 

Cheap Photo box that will get the job done

WEll i took on this project for PP hes a hardware reviewer and wants to get the professional looking pics for the Pc parts

Materials:

• Big cardboard box

• a razor

• white material 3 yards

• cone lights

• stapler

• medical tape

• pvc pipe about 6 inches longer than your box

• white paint any cheap finger paint would work

the project I'm guessing will cost me $30 if it works out properly
I will post pictures and step by step as i do it