Windows 10: Start up fail

Processor AMD Athlontm II X4 635 Processor 2.90 GHz Installed RAM 16.0 GB Device ID C8FBED17-0E45-4652-ADE3-696069A09B74 Product ID 00330-80000-00000-AA309 System type 64-bit operating system, x64-based processor Pen and touch No pen or touch input is available for this display Edition Windows 10 Pro Version 20H2 Installed on ‎7/‎15/‎2021 OS build 19042.1110 Experience Windows Feature Experience Pack 120.2212.3530.0 This is the info on my computer YES IT IS OLD but does what I need it for.When I first turn on goes thru its thing until it gets to the first Windows symbol and that is it no s

:)

 

Windows 10 fails to update


When you finish testing the Avast suggestion, make sure that you restart your machine.

Then if the issue persists, please return to the trouble shooting list in post# 89

I think there are three steps that remain; the WU troubleshooter, reset WU components, and manual WU reset.

 

KB4025339 Fails Install 0x80070564

Thanks
I am trying Eagle 51's suggestions now. Windows Update troubleshooter found a bunch of errors and fixed all but one.The update is trying to download KB4025339 again. I'll see what happens. At step one troubleshooter finishes with one error unresolved "Potential Windows Update Database Error Detected-Not Fixed". Windows update stalled at 0%.

At step 2 same troubleshooter error. The KB finished a new download failed to install.
Did step 3 KB has downloaded but fails to install.

If Eagle's suggestion doesn't work I'll try EdTittel's suggestion

Tried bothe Eagle & Ed 's suggestions - do not work. Anyone else?

I have noticed that the latest update for my nvidia drivers has failed to update. Wondering about that!

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".